Improper shut down of the SpectrAA Software Restart the autosampler, ensure that autosampler initialization process is completed successfully with no errors then open the SpectrAA Software The autosampler probe moves on all three axes and there are no error LEDs on the autosampler when the movements are completed. Your IT Department may be required to check these settings and operationĮnsure that the autosampler initialization process is completed successfully with no errors before opening SpectrAA Software.
If using a USB to serial adaptor (or cable), confirm it is mapped to COM1. The autosampler must use COM1 for the communication setting on the PC.
Incorrectly selected or configured COM port on the PC Table 1: Sources of error and action to correct Error source To identify a hardware fault, refer to Agilent SPS 3 Autosampler Initialization Sequence and Troubleshooting OR Agilent SPS 4 Autosampler Initialization Sequence and Troubleshooting. Table 1 contains the possible sources for the error, and actions to identify and correct the problem. If these actions do not correct the error, the error will be an autosampler hardware fault or corrupted firmware. Successful communication displays status Sampler Online.įigure 1. Please follow the steps in the Microsoft article given below. Table 1 contains the possible sources for the error, and actions to identify and correct the problem. Successful communication displays status Sampler Online. Colour Depth Problems, X Wont Do What Its Told Page:1 xvidcap, ffmpeg and co. The Sampler Offline message indicates that the PC/SpectrAA Software is not communicating with the autosampler. Method 1: Let’s try to run Printer troubleshooter and check if it works. Page:1 Chromium and Firefox do NOT play nice together. NOTE: You can use the third option only when you are connected locally, that is your mobile. Tap on the yellow ‘know more’/’why offline’ button and re-register your camera following the on-screen instructions. I would suggest you to try the following methods and check if that helps. Refresh your camera list by pulling it down with your finger.
The Sampler Offline message ( Figure 1) indicates that the PC/SpectrAA Software is not communicating with the autosampler. This issue might have occurred due to corrupt printer drivers or the printer drivers have not installed properly in the computer. Issue: The Agilent SPS 3 or SPS 4 autosampler performs its power-up initialization sequence, but displays Sampler Offline status in SpectrAA Software in the Optimize page. This feature may not be available in all countries due to technical limitations or local law.This Information Applies To:Agilent Spectroscopy Systems, SPS 3, SPS 4 Autosamplers
Location Services is not enabled on your iPhone, iPad, or iPod Touch (Settings > Privacy) or on your Mac (Date & Time) preferences.
Your iPad (Wi-Fi only), iPod Touch, or Mac is currently off or not connected to a Wi-Fi network.Your iOS device is currently off or not connected to a data network (Edge, 3 or 4G, or Wi-Fi).Choose Settings > General > Date & Time to check and set the date.
"No location available," "Offline," or "Location Services Off" alerts ICloud: Troubleshooting Find My iPhone, iPad, iPod touch, or Mac This article has steps you can take to troubleshoot Find My iPhone: So, Ive added the 'sound alerts' extenion to my twitch stream and panel. Thanks for using Apple Support Communities.